一. 在升级前必须对以下的组件升级
1. 升级 device-mapper,在 ftp://sources.redhat.com/pub/dm下载
cd /usr/src
tar -zxvf device-mapper.1.01.04.tgz
cd device-mapper.1.01.04
./configure --perfix=/
make all
make install

2. 安装 LVM2,在 ftp://sources.redhat.com/pub/lvm2下载
cd /usr/src
tar -zxvf LVM2.2.01.14.tgz
cd LVM2.2.01.14
./configure --perfix=/
make all
make install

3. 升级 mkinitrd 在 http://rpm.pbone.net/ 下查找
rpm -Uvh mkinitrd-3.5.11-3.9.i386.rpm

4.update modutils 在 ftp://ftp.kernel.org/pub/linux/utils/kernel/modutils/下载
cd /usr/src
tar -zxvf modutils-2.4.27.tar.gz
cd modutils-2.4.27
./configure --perfix=/
make all
make install

5.安装module-init-tools,在 ftp://ftp.kernel.org/pub/linux/utils/kernel/module-init-tools 下载
cd /usr/src
tar -zxvf module-init-tools-3.2-pre9.tar.gz
cd module-init-tools-3.2-pre9
./configure --prefix=/
make moveold

ps:"make moveold"将把系统原来的modutils工具程序改名为"*.old"(比如,lsmod.old等,是非常重要的一步! 如果忘记了这一步也不要紧张, 可以按照上面的步骤4重装一遍modutils就可以了.

make

ps: 用module-init-tools-3.1 编译时会出现 "make: *** [modprobe.conf.5] Error 127"

建议用 3.0 或 3.2-pre 版

make install
./generate-modprobe.conf /etc/modprobe.conf

标签:
升级,系统,make,cd,/usr/src,-zxvf,./configure,install

免责声明:本站文章均来自网站采集或用户投稿,网站不提供任何软件下载或自行开发的软件! 如有用户或公司发现本站内容信息存在侵权行为,请邮件告知! 858582#qq.com
内蒙古资源网 Copyright www.nmgbbs.com

评论“LINUX系统2.4内核升级到2.6内核”

暂无“LINUX系统2.4内核升级到2.6内核”评论...

RTX 5090要首发 性能要翻倍!三星展示GDDR7显存

三星在GTC上展示了专为下一代游戏GPU设计的GDDR7内存。

首次推出的GDDR7内存模块密度为16GB,每个模块容量为2GB。其速度预设为32 Gbps(PAM3),但也可以降至28 Gbps,以提高产量和初始阶段的整体性能和成本效益。

据三星表示,GDDR7内存的能效将提高20%,同时工作电压仅为1.1V,低于标准的1.2V。通过采用更新的封装材料和优化的电路设计,使得在高速运行时的发热量降低,GDDR7的热阻比GDDR6降低了70%。